What happens in each cycle – Whirlpool 4LA6300XX User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Select cycle and wash time
Start the washer
• Push in the Cycle Control Knob and
turn it clockwise.
• Stop when the indicator on the
knob's outer ring points to the
number in the wash cycle you want.
The numbers are minutes of wash
time.
• Start the washer by pulling out the
Cycle Control Knob. The washer will
fill to the selected water level with
the selected wash water tempera
ture. The washer will begin agitating
immediately after filling. Agitation
can occur with the washer lid up or
down.
• To stop the washer at any time, push
in the Cycle Control Knob. To restart
the washer, pull out the Cycle
Control Knob.
What happens in each
cycle
Each cycle has been designed for
different kinds of fabrics.
When the Cycle Control Knob is set
to a number and pulled out, the wash
er fills before agitation and timing
starts. After agitation starts, the knob
turns clockwise until it points to OFF
and the cycle ends.
The washer will pause briefly
throughout each cycle. These pauses
are normal for washer operation.
Gentle Wash System
For better fabric care in the REGULAR
and PERMANENT PRESS Cycles, the
agitation speed is reduced during the
last few minutes of wash agitation
time.