Soak cycle, Liquid bleach dispenser, Magic clean’lint filler – Whirlpool 6LA58OOXT User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Soak Cycle

For best results, use warm water for

soaking stained laundry. Hot water can
set stains.

1. Use recommended amount of

detergent or pre-soak product.

2. Push Cycle Control Knob in.
3. Turn clockwise to point to the

number in the SOAK Cycle.

4. Pull the Cycle Control Knob out. The

washer will start.

5. When the cycle is over, add

detergent for the next selected wash
cycle. The SOAK Cycle should al­
ways be followed by a wash cycle.

Liquid bleach dispenser

Always measure bleach. Do not guess.

Never use more than 1 cup (250 ml) for

a full load. Use less with lower water
level settings. Follow directions on
bottle for safe use. Use a cup with a
pouring spout to avoid spilling.
1. Load the washer first.
2. Pour measured bleach carefully into

dispenser. Do not let bleach splash,
drip or run down into washer basket.

Undiluted bleach will damage any

fabric it touches.

3. Start the washer. Bleach will be

diluted automatically during the
wash part of the cycle.

lint filter

interior

MAGIC CLEAN’lint filler

The lint filter at the bottom of the
washer basket cleans itself. During agi­
tation, wash and rinse water pass over
the filter, separating lint from water.
The collected particles of lint are then
continuously spun away from the filter
and washed out of the system at the
end of the wash cycle.

If your washer drains into a tub,

remove any lint collected in the tub
or strainer.

11

Advertising