Removing the drop-in door trim (dispenser area), To repiace the trim piece, Adjusting the cantilever refrigerator shelves – Whirlpool 2194182 User Manual
Page 9: To remove a sheif, Removing the drop-in door trim, Dispenser area)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
U S I N G Y O U R R E F R I G E R A T O R
Removing the drop-in door trim
(dispenser area)
(on some models)
Remove the trim above the dispenser area
for easier cleaning.
To remove the trim piece:
1. Remove all items from the shelf.
2. Pull straight up on the trim piece at
each end.
To repiace the trim piece:
1. Locate each end of the trim piece above
the trim pocket opening.
2. Push the trim piece straight down until
it stops.
3. Replace items on the shelf.
Adjusting the cantilever refrigerator shelves
Adjust the shelves to match the way you use
your refrigerator. Glass shelves are strong
enough to hold bottles, milk, and other
heavy food items.
To remove a sheif:
1. Remove items from shelf.
2. Tilt shelf up at front.
3. Lift shelf at back.
4. Pull shelf straight out.
To replace a shelf:
1. Guide the rear shelf hooks into the
slots in the shelf supports on the back
liner wall.
2. Tilt front of shelf up until hooks drop
into slots.
3. Lower front of shelf to a level position.
NOTE: Glass shelves are heavy. Handle
them carefully.