Whirlpool 7LSC9245BN0R - Manual (Page 12)

O P E R A T I N G Y O U R W A S H E R
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to
the selected load size) before agitation and
timing start. The washer begins agitating
immediately after filling; agitation can occur
with the washer lid up or down. After agita­
tion starts, the Cycle Control Knob turns
clockwise until it points to an OFF area and
the cycle ends.
WASH
Fill
JÏI
Wash selected time*
*lf high-speed agitation is selected, agitation
speed is reduced in the last few minutes of
most cycles. This provides better fabric care.
Drain (or partial drain*)
No agitation
'The Permanent Press cyde partially
drains, fills, agitates briefly, and drains.
Spin
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
NOTE: The Gentle Wash System helps
protect your fabrics (if high-speed agitation is
selected) by reducing wash agitation speed
during the last few minutes of wash agitation
in the Heavy, Regular, and Permanent
Press cycles.
RINSE
hr Rll
Rinse
Drain-No agitation
Spin-Spray rinse
Spin
A Off
MAGIC CLEAN* lint filter
The lint fiKer at the bottom of the washer
basket cleans itself. During agitation, wash
and rinse water passes over the filter,
separating the lint from the water. The lint is
then spun away from the filter and out of the
system during the spin part of the cycle.
If your washer drains into a tub, remove
any lint collected in the tub or strainer.
MAGIC CLEAN Basket
lint filter
interior
12