GE AEE08AR - Manual (Page 9)

Window Installation Instructions
H WINDOW REQUIREMENTS
• These instructions are for a standard
double-hung window. You will need to modify
them for other types of windows.
A
c
AUTION:
If the sill support bolts
do not contact the window sill or if you have a
window without a sill, you must order accessory
kit RAK87 to properly install this air conditioner.
Call 800.626.2002 or visit GEAppliances.com.
• All supporting parts must be secured to firm
wood, masonry or metal.
• The electrical outlet must be within reach of
the power cord.
I
I
15.4" min.
27" to 35"
(With accordion panels)
STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will
keep it from draining properly. To adjust for this,
attach a piece of wood to the stool.
WOOD PIECES-
WIDTH: 2"
LENGTH: Long enough to fit inside the window
frame.
THICKNESS: The top of the wood should be 1/2"
higher than the top of the storm window frame
or the vinyl frame.
Attach securely with nails or screws provided
by the installer.
1/2" higher
than storm
window
frame
Storm window
frame
tnc
1/2" higher
than vinyl frame
(on some windows)
'Wood
nTii
Hv
stool
Vinyl frame
r
2 REMOVE THE AIR CONDITIONER FROM
THE CASE
Remove and save the 2 screws from the lower
sides of the front grille.
FRONT
Grasp the lower corners of the grille while
pressing in on the case sides with your finger
tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge toward you
more than 3" or you may damage the tabs of
the grille.
FRONT
0 When the front grille is removed the control
panel will still be attached by a harness.