Cobra Electronics BAND XRS 9670 - Manual (Page 14)

Settings
Your Detector
Nothing Comes Close to a Cobra ® 23
Settings
Your Detector
22 English
DigiView Data Display Brightness
Your detector has a Bright display mode (for daytime driving) and three
levels of Dim display modes (Dim for dusk driving, Dimmer for night driving
and Dark where no visual alerts will be displayed) to control the display’s
brightness levels. The factory setting is Bright. The factory Dim mode
default setting is Dimmer.
Dark Indicator
.
To Change the Brightness to Dim
Press and release the
Select/Dim button once.
Tone Visual Display
Two beeps Dim, Dimmer or Dark
To Change the Brightness to Bright
Press and release the
Select/Dim button again.
Tone Visual Display
One beep Bright
NOTE
When you change to Dim mode, the unit will enter
whichever dim default mode is set at the time.
Dim Display
Dim
Bright Display
Bright
Dimmer Display
Dimmer
Dark Display
Dark
SmartPower
Your detector includes the SmartPower feature that, when activated, will put
the unit into Standby mode (low power) for about 30 minutes after the car’s
engine has been turned Off. After 30 minutes in Standby mode, the unit will
automatically turn Off.
Before SmartPower enters Standby mode, you will hear one
beep and Pwr Save will appear on the display. To return
the unit to normal Power mode or exit Standby mode, start
the car, press any button or turn the unit Off and then On
again. The factory setting is SmartPower On.
SmartPower Entering
Standby Mode
Pwr Save
...Power On ...Power Off
To Turn SmartPower Mode On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
go to SmartPower.
Tone Visual Display
Two beeps SmartPower On
One beep SmartPower Off
Select/Dim
Button
XRS9670_MANL_A.indd 22-23 8/30/10 8:37 AM