GE 164D2966P127-I - Manual (Page 31)

n\
How to Set Oven for Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad until
the desired Clean Time appears.
3. Press the START pad.
If the oven is too hot and you start to set a clean cycle,
the word “OFF” will appear in the display. Allow
additional time for cooling before you try to
set the cycle.
1. Follow directions in the Before a Clean
Cycle section.
2. After closing the door, press the
AUTO SELF CLEAN pad.
AUTO SELF
CLEAN
3. Press the INCREASE or DECREASE
pad until the desired Clean Time is
displayed in the lower left display.
Clean Time is normally 3 hours.
You can change the Clean Time to
anytime between 2 and 4 hours,
depending on the amount of soil in
your oven.
4. Press the START pad.
The lower right display shows the calculated Stop
Time. “LOCKED” flashes in the display while the
door locks automatically, then it appears steadily. It
will not be possible to open the oven door until the
temperature drops below the lock temperature and the
LOCK light goes off.
5. When the LOCK light is off, open the door.
NOTE: Both the lower oven fan and the microwave
fan may operate during the self-clean function and
continue to operate until the oven temperature has
cooled. This is normal, and the fans may continue
to run even after the oven is turned off.
c
ft)
n
P
a
P
(TQ
cr
ft)
ft)
Q
p
0
0
dQ
O
<5
ft)
0
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad. 2. When the LOCK light goes off and the oven has
cooled below the locking temperature, open the
door.
(continued next page)
31