Operating the self-cleaning oven, After self-cleaning, How to set delay start of cleaning – GE 164D2966P127-I User Manual
Page 32: Clean
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

m
OPERATING THE SELF-CLEANING OVEN
(continued)
After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are usually
a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad until
the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
5. Press the START pad.
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the directions in the Before a Clean
Cycle section.
2. Press the AUTO SELF CLEAN pad.
AUTO SELF
CLEAN
3. Press the INCREASE or DECREASE
pad to enter the desired Clean Time.
, Press the STOP TIME pad.
The earliest Stop Time will be the
Clean Time selected plus the time
of day.
For example:
If the Clean
Time is 3 hours and the time of day is
6:00, the Stop Time that appears on
the display will be 9:00.
5. Press the INCREASE or DECREASE
pad to change the Stop Time to a
later time of day if desired.
For example:
If you set Stop Time
at 11:00, oven will start clean cycle
at 8:00 and end at 11:00. The door
latches automatically.
6. Press the START pad.
The lower left display shows the Clean Time and
the lower right display shows the Stop Time.
“LOCKED” flashes in the display while the door
locks automatically, then it appears steadily. It will
not be possible to open the oven door until the
temperature drops below the lock temperature and
the lock light goes off.
7. When the lock light is off, open the door.
NOTE: Both the lower oven fan and the microwave
fan may operate during the self-clean function and
continue to operate until the oven temperature has
cooled. This is normal, and the fans may continue to
run even after the oven is turned off.
32