Kenmore POWER MISER 153.330551 - Manual (Page 19)

Operating Instructions (cont’d)
Temperature Regulation
Due to the nature of the typical gas water heater, the water tem-
erature in certain situations may vary up to 30°F higher or
ower at the point of use such as, bathtubs, showers, sink, etc.
f
Ic
This means that when the temperature adjustment dial is set at
the mark approximating 120°F, the actual water temperature at
any hot water tap could be as high as 150°F or as low as 90°F.
Any water heater’s intended purpose is to heat water. Hot water
is needed for cleaning (bodies, dishes, clothing). Hot water will
present a scald hazard. Depending on the time element, and the
people involved (normal adults, children, toddlers, elderly,
infirm, etc.) scalding may occur at different temperatures.
AWARNING
HOTTER WATER CAN SCALD: Water heaters are intended to
produce hot water. Water heated to a temperature which will
satisfy clothes washing, dish washing, and otiW sanitizing needs
can ^d and permanently injure you upon contact Some peo­
ple are more likely to be permanently injured by hot water than
others. These include the elderly, children, the infirm, or physical-
ly/mentally handicapped. If anyone using hot water in your home
to into one of these groups or if there is a local code or state law
requiring a certain temperature water at the hot water tap, then
you must take special precautions. In addition to using the lowest
possible temperature setting that satisfies your hot water needs,
a means such as a mbdng valve, should be used at the hot water
taps used by these people or at the water heater. Mbdng valves
are availaUe at plumbing supply or hardware stores. Follow man-
ufocturers instructions for installation of the valves. Before
changing the factory setting on the thermostat, read the
“Temperature Regulation” section in this manuai.
AWARNING
Never allow small children to use a hot water tap, or to draw
their own bath water. Never leave a child or handicapped per­
son unattended in a bathtub or shower.
The thermostat of this water heater has been factory set at its
lowest position, to reduce the risk of scald injury. It is adjustable
and must be reset to the desired temperature setting. The mark
(A)
indicative of approximately 120“F is the preferred starting
point. Some states have a requirement for a lower setting. If you
need hotter water, follow directions for temperature adjustment,
but beware of the warnings in this section.
Turn the water temperature dial clockwise %) to decrease
the temperature, or counterclockwise ^) to increase the
temperature.
PILOT
LIGHTING Set here before lighting pilot.
A
- Is a thermostat setting of approximately
120”F, which will supply hot water at the
most economical temperatures. The tempera­
ture adjustment knob can be turned lower
than 120°F if desired.
A - Is a thermostat setting of approximately
130-F.
B - Is a thermostat setting of approximately
140”F.
C - Is a thermostat setting of approximately
150“F.
VERY HOT — Is a thermostat setting of 160“F, It is recom­
mended that the dial be set lower whenever
possible,
NOTE: Water temperature range of 120“—140“F recom­
mended by most dishwasher manu&ctuters.
AWARNING
Should overheating occur or the ga$ supply fall to shut off,
turn “OFF’ the manual gas control valve to the appliance.
19