Window installation—12000, and 18000 btu units, Models 70129,78189), Required tools and equipment – Kenmore 70089 User Manual
Page 12: Vs" drill bit installation kit parts, Caution, Installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
Window Installation—12000, and 18000 Btu
Units
Models 70129,78189)___________________
A
CAUTION
To avoid risk of personal injury, property damage, or
product damage due to weight of device and sharp
edges that may be exposed:
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install unit. To prevent injury
or strain, use proper lifting and carrying methods.
• Carefully inspect location where air conditioner
will be installed. Be sure it will support weight of
unit for extended period of time.
- Handle air conditioner with care. Wear protective
gloves whenever lifting or carrying unit. AVOID
sharp metal fins on front and rear coils.
- Make sure air conditioner does not fall during
installation.
Required Tools and Equipment
• Tight-fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• Carpenters’level
• W open-end wrench or adjustable wrench
•
hex socket and ratchet
• Tape measure
• Electric drill
• Vs" drill bit
Installation Kit Parts
Window installation kits contain the following parts. Be
sure all parts are included before starting installation. If
parts are missing, contact Sears.
NOTE:
Parts are listed in the order used and are
illustrated in Figure 16.
Item
#
Description
Quantity
A
Window sill gasket {W x 14")
44"
B
V
b
" countersunk wood screw
2
C
4" adjusting foot
2
D
Outside support
2
E
yz" screw
2
F
Sash bracket
1
G
7e" sash bracket screw
1
H
®/
b
" Phillips screw
2
I
Window seal strip (%" x 1W)
48“
J
Basepan Clip
1
K
14" screw
1