To clean agitator, To replace belt – Kenmore 116.23637C User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO CLEAN AGITATOR
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu
um, the agitator must be cleaned every time
the belt is changed.
The agitator must also be cleaned accord
ing to the following schedule:
Vacuum Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1time/week)
Clean Agitator
every week
every month
every 2 months
TO REPLACE BELT
1. Install new
belt over motor
drive, then
over brush
sprocket.
NOTE: See
PARTS AND
FEATURES for
belt number.
Motor
Drive
End Cap
Agitator
2. Place agitator
assembly back
into Power-Mate®!
3. Reinstall
agitator
cover by lin
ing up the
front tabs
and slots
and rotating
downward
until the
latches snap into place.
4. Line up
front of
cover and
base. Rest
cover on
front edge
of base as
shown.
5. Rotate cover
back. Press
cover firmly
until side and
rear tabs snap
into place. Turn
Power-Mate®
upside down
and replace two
(2) cover
screws.
17