Kenmore 417.8413 - Manual (Page 19)

Solutions to Common Problems
Avoid Service Checklist, continued
DISPLAYED IN LCD POSSIBLE CAUSE SOLUTION
Check Exhaust
(Displayed during or at the end
of a full cycle)
Check Exhaust feature has detected perfor­
mance issues related to vent restriction.
Immediately inspect your venting system and make any
repairs or perform any cleaning procedures necessary.
Check Exhaust feature has detected perfor­
mance issues from overloading dryer drum.
Reduce load in drum and restart.
Check Exhaust
(Displayed at the end of a short,
terminated cycle, leaving a wet
load in the drum)
Check Exhaust alerts have been overlooked and
the dryer shuts down after a fev/ minutes.
Immediately inspect your venting system and make any
repairs or perform any cleaning procedures necessary.
Service Cord Incorrectly installed service cord on electric dryer. Unplug dryer and refer to Installation Instructions for
correct service cord v/iring procedures.
Load to small Load is too small to estimate correct dry time in
Auto Dry cycle.
Dry items in a Timed Dry cycle.
No Gas Gas is not detected at burner tube of gas dryer. Inspect that gas line connection is still installed on dryer
gas inlet, and fully open gas supply valve. If gas line is
not yet installed, correctly install gas line connection ac­
cording to Installation Instructions.
Call Service Error detected can only be resolved by calling
service technician.
Call 1-800-4-MY-HOME (1-800-469-4663) for assis­
tance.
19