Before ¥ou'cais, Problem cause correction – FRIGIDAIRE Refrigerator User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

1 -800-944-9044.

(United States)

1-866-213-9397

(Canada)

■Before ¥ou'CaiS'

Visit ourweb .site at

■ aMmJrigidMre.c^^^^

PROBLEM

CAUSE

CORRECTION

RUNNING OF REFRIGERATOR

Compressor does not run.

Cooling system is turned Off.

Refrigerator is in defrost cycle.

Plug at wall outlet is
disconnected.

House fuse blown or tripped

circuit breaker.

Power outage.

Turn cooling system On. See

Temperature Controls

section.

This is normai for a fully automatic defrost refrigerator.

The defrost cycle occurs periodically, lasting about 30

minutes.

Ensure plug is tightly pushed into outlet.

Check/replace fuse with a 15 amp time-delay fuse.
Reset circuit breaker.

Check house lights. Call local Electric Company.

Refrigerator runs too
much or too long.

Room or outside weather is
hot.

Refrigerator has recently been
disconnected for a period of

time.

Automatic ice maker is

operating.

Doors are opened too

frequently or too long.

Refrigerator/freezer door may
be slightly open.

Freezer control is set too cold
(control found in refrigerator
section).

Refrigerator/freezer gasket is
dirty, worn, cracked, or poorly

fitted.

It’s normal for the refrigerator to work longer under

these conditions.

It takes 8-12 hours for fhe refrigerator to cool down

completely.

Ice maker operation causes refrigerator to run slightly

more.

Warm air entering the refrigerator causes it to run

more. Open doors less often.

Ensure refrigerator is level. Keep food and containers

from blocking door. See

PROBLEM

section

OPENING/CLOSING OF DOORS/DRAWERS.

Set refrigerator control to warmer setting until
refrigerator temperature is satisfactory. Allow 24 hours
for temperature to stabilize.

Clean or change gasket. Leaks in door seal will cause
refrigerator to run longer in order to maintain desired
temperatures.

Compressor goes off and
on frequently.

• Electronic control system

keeps the refrigerator at a

constant temperature.

• This is normal. Refrigerator goes on and off to keep

temperature constant.

Digital temperature
displays are flashing.

• Electronic control system has

detected a performance
problem.

• Call your Frigidaire service representative, who can

interpret any messages or number codes flashing on

the digital displays.

TEMPERATURES ARE TOO COLD

Freezer temperature too
cold. Refrigerator

temperature is satisfactory.

• Freezer control is set too cold.

• Set freezer control to a warmer setting. Allow 24 hours

for temperature to stabilize.

Refrigerator temperature

too cold. Freezer
temperature is satisfactory.

• Refrigerator control is set too

cold.

• Set refrigerator control to a warmer setting. Allow 24

hours for temperature to stabilize.

Food stored in drawers

freezes.

• Refrigerator control is set too

cold.

• See solution above.

Food stored in Meat
Keeper freezes (some
models).

• Meat Keeper Temperature

Control set too cold.

• Adjust Meat Keeper Temperature Control to a lower

setting. (Meat should be stored at a temperature just
below the freezing point for maximum fresh storage
time. It is normal for ice crystals to form due to the
moisture content of meat.)

23

Advertising