FRIGIDAIRE 131888900 - Manual (Page 2)

INSTALLATION INSTRUCTIONS
DOOR LOCK/SWITCH KIT - P/N 131888900
2
.
3.
4.
5.
6 .
7.
8
.
9.
This kit replaces the Bitron door lock/switch with a US Controls door lock/switch.
This kit contains the following parts:
(1) Door Lock/Switch
(1) Door Strike
(1) Adapter Harness
(1) Tube Adhesive
(6) Plastic Harness Ties
(1) Installation Instruction
Disconnect the washer from the electrical power
source.
Remove the front service panel.
Open the door, remove the two screws securing the
door strike to the door and remove the strike.
Install the new door strike using the screws removed
in step 3.
Using a razor blade or a sharp putty knife, separate
the bellows from the front panel at the 2, 3, & 4
o’clock positions.
Remove the screws securing the old door
lock/switch to the front panel.
Remove the wires from the old door lock/switch and
remove the switch.
Remove the nine pin plug from the speed control
unit (SCU).
NOTE: If the washer serial number prefix is XC703
and above, go to step 13. If the washer serial number
is below XC703, proceed with instructions 10
through 12.
11. Pull the red wire out of the slot.
12. Insert the red wire into slot number 4 until the
terminal clicks into the housing. Gently pull on the
wire to ensure it is fully seated in the housing.
10. In slot number 2, insert a small wire (paper clip)
between the locking tab of the red wire terminal and
the housing. Note: The locking tab is located in the
small rectangular slot below the terminal. DO NOT
push down on the contact prongs on the wire
terminal.
13. Remove the connector plug from the pump. NOTE:
Removing the pump cover on pumps with an
external cooling fiin will make it easier to access the
connector plug.
14. Connect the nine pin plug from the adapter harness
to the to the SCU.
P/N 131888800 8/99