Kenmore 385.19005 - Manual (Page 55)

Twin Needle Sewing
Press the twin needle key (T) to enter the twin needle
sewing mode. The single needle icon changes to twin
needle icon.
The stitch patterns that cannot be sewn with twin needle
are grayed out. The limit of stitch width for twin needle
sewing will be set automatically,
I Notes:
i " When you sew patter ns with the twin needle, test the
I stitches first before sewing,
I Use zigzag foot or satin stitch foot for twin needle
I sewing. Try satin stitch foot when zigzag foot makes a
■ wrinkled appearance and distorted patter n on the fabric.
• You can not sew the following patterns with twin needle;
4, 7, 8 , 9, 12, 13, 14, 15, 16. 17, 22. 23, 24, 27, 29, 30,
31,32, 33, 34 and 35.
® To sew
Set an additional spool pin and spool stand. Put a felt on
the spool pin. Insert the another spool to the additional
spool pin (see page 13) Draw both threads from the
spools and pass them through the points from
1 to 4
Make sure that the two strings of thread from the spools
will not get tangled.
Slide one of the threads through the needle bar thread
guide on the left, and the other one on the right
Thread the needles from the front to back..
Select the desired pattern and sew
Notes:
i «Make sure each of the threads wind off from the spools
i as shown
i ° The built-in needle threader cannot be used for the twin
: needle.
" When changing the sewing direction, raise the needle
and turn the fabric.
fl)
50