Kenmore 141.178600 - Manual (Page 10)

Assembling The Cabinet Doors Figure 4
1. Install Door Stops to Bottom Shelf and Top
Panel of Cabinet. See Fig. 4. Secure firmly
using 4 of the 1/4"x1/2" Phillips head screws
and nuts.
2. If you haven't already done so, remove the
white protective film from the stainless steel
Doors. Attach a Door Handle to each Front
Door using 2 of the lVI4x6mm Phillips head
screws provided. See
Fig. 5. Be careful not to
scratch the door surfaces.
3. When installing the Front Doors, make sure
the door bolt holes are located on the hinge
sides of the Cart Legs.
4. Install either Front Door by inserting 1/4"x5/8"
part-threaded bolt through the lower door bolt
hole of the Front Door and into the tapped
hole of the Bottom Shelf. Tighten securely.
Next, align the upper door bolt hole of Front
Door with the tapped hole in the Top Panel of
Cabinet. Insert 1M"x5/8" part-threaded bolt
provided and tighten securely.
5. Repeat these steps to install the other Front Door.
How To Level The Grill Cart So The Doors Line-Up
When the top edge of the cabinet doors do not line-up
your grill cart needs to be leveled. This step is often
required after initial assembly and when your grill has
been moved to a new location. To level your grill cart,
use an 11/16" open-end wrench to unscrew either front
or rear Castor counterclockwise from its Castor Seat
(see bottom of the Cart Leg) until the cabinet doors are
aligned. See
Fig. 5.
Figure 5
10