Basic lighting procedures, Lighting your grill by match, Figure 16 – Kenmore 141.178600 User Manual

Page 17: Grill lighting instructions, Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

A

warning

A strong gas smell, or the hissing sound of
gas indicates a serious problem with your gas
grill or the LP gas tank. Failure to immedi­
ately follow the steps listed below couid result

in a fire or explosion that could cause serious
bodily injury, death, or property damage.

• Shut off gas supply to the gas grill.
• Turn the control knobs to OFF position.
• Put out any flame with a fire extinguisher.
• Open grill lid.
• Get away from the LP gas tank.
• Do not try to fix the problem yourself.
• If odor continues or you have a fire you

cannot extinguish, call your fire

department.

Do not call near the LP

gas tank

because your telephone is

an electrical

device and could create a

spark resulting

—in firo and/or cxplooion.----------------------------------------------

Checking For LP Gas Leaks

Never

test for leaks with a flame. Prior to first

use, at the beginning of each season, or every

time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:

1. Make a soap solution by mixing one part

liquid detergent and one part water.

2. Turn the grill control knobs to the full OFF

position, then turn the gas ON at source,

3. Apply the soap solution to all gas

connections. If bubbles appear in the soap
solution the connections are not properly
sealed. Check each fitting and tighten or

repair as necessary.

4. If you have a gas leak that you cannot

repair, turn off the gas at the source, discon­
nect fuel line from your grill and call
1-800-4-MY-HOME or your gas supplier for
repair assistance.

Grill Lighting Instructions

Basic Lighting Procedures

1, Familiarize yourself with the safety guidelines at

the front of this manual. Do not smoke while

lighting grill or checking gas supply connections.

2, Be sure the LP gas tank is filled.

3

, Check that the end of each burner tube is properly

located over each valve orifice.

4, Make sure all gas connections are securely

tightened.

5, Open the Grill Lid or Side Burner Lid, depending on

the burner you are lighting.

A

WARNING

Failure to open Grill or Side Burner Lid

during the lighting procedures could

result in a fire or explosion that couid

cause serious bodily injury, death, or

property damage.

6. Set control knobs to OFF and open the LP gas

tank valve slowly until 1/4 to 1/2 open.

7. For grill lighting push and turn the LEFT control

knob to HIGH. To light the Side Burner turn its

control knob to HIGH.

8. Immediately press the electric ignitor for 3-4

seconds to light the burner.

9. If the burner does not light, turn the control knob to

OFF, wait 5 minutes for gas to clear, then retry.

10- Once the left grill burner is ignited, the adjacent

burner can be lit by simply turning its control knob

to HIGH.

11 • Adjust control knobs to your desired cooking

temperature.

Lighting Your Grill by Match

To light your gas grill by match, follow steps 1 through
6 of the Basic Lighting Procedures. Then, insert a lit

match through the lighting hole on either side of the

grill. See

Fig. 16.

Turn the nearest control knob to the

HIGH setting to release gas. The burner should light
immediately.

Figure 16

A

warning

Never

lean over the grill cooking area while

lighting your gas grill. Keep your face and
body a safe distance (at least 18 inches)

from the lighting hole or burners, when

lighting your grill by match.

17

Advertising