Kenmore 122.166489 - Manual (Page 13)

Light Operation Instructions
1 .Make sure the light power switch on the control
panel is in the “OFF” position.
2.Turn the light power switch to “OFF.”
A
WARNING
Keep any electrical supply cord away from any
heated surface.
Halogen Bulb Replacement
1 .Make sure that the grill has cooled before changing the
light bulb.
2.Make sure the light’s power switch on the control panel
is in the “OFF” position and power plug is disconnected
from the outlet.
S.Use a Phillips screwdriver to loosen 8pcs screws & 8pcs
washers securing the light rear cover on the left end and
the right end as Picture A shown.
NOTE: When removing final screw from lamp rear cover,
make sure to use other hand to hold the cover in place,
ensuring it doesn’t fall and damage.
Picture A
Picture B
0
1
o
o
4. Loose one screw securing the light glass cover ,.
also need to use other hand to hold the cover,
ensuring it doesn’t fall and shatter.
As shown in Picture B
5.Remove the glass cover from the light bulb housing.
See Picture C&D.
Picture C
HINT: Use a flathead screwdriver to open it easily.
Picture D
6. Use a flathead screwdriver to loosen the four screws
locking the bulb in place.
Loosen but do not remove four screws from light first as
picture E shown.
Picture E
\\^
m
1 2