Pioneer MJ-D508 - Manual (Page 44)

Error Messages
Message Description Action
No Disc ❖ MD is not loaded. ❖ Load an MD.
❖ The MD data cannot be read. ❖ Reload the MD.
Disc ERR ❖ The disc is damaged. ❖ Reload the MD.
❖ The MD does not contain the TOC or the data is ❖ Use another MD.
?Disc
corrupted.
❖ The data is corrupted or the MD is out of standard. ❖ Use another MD.
Disc Full ❖ The MD has no space available for recording. ❖ Use another recordable MD.
Blank Disc ❖ The MD does not contain any recorded information ❖ The disc is ready to be recorded on.
Playback MD
(including disc name information).
❖ An attempt is made to record or edit a playback-only ❖ Use a recordable MD.
Protected
MD.
❖ The MD is protected against accidental erasure. ❖ Release the accidental erasure protection.
TOC Full ❖ The disc does not have the space for recording the ❖ Use another recordable MD.
Can't REC
track number and character data (including disc/
track names).
❖ Recording cannot be completed successfully due to ❖ Restart recording or use another MD.
Temp Over
shock or disc damage.
❖ The temperature is too high. ❖ Turn power off and leave to cool.
Can't Edit ❖ Editing is not possible. ❖ Retry at another position on the disc.
Name Full ❖ There is no space left for registering a disc/track ❖ Shorten the disc/track name.
Defect
name.
❖ Recording interrupted due to disc damage. ❖ Use another recordable MD.
MECHAERR^ ❖ The MD recorder is not tunctioning properly. ❖ Turn power off then on again..
Can't Copy ❖ An attempt is made to record copy-prohibited ❖ Use a copy-permitted source (an ordinary
Not Audio
material.
❖ The disc contains non-audio data.
CD, etc.).
❖ Record the analog input from the source.
❖ Use another track.
UTOC WERR ❖ The UTOC data cannot be written properly due to
❖ Use another MD.
❖ Turn power off and on again, then retry
UTOC ERR^
physical shock or disc damage.
❖ The recorded UTOC data is not conforming to the
UTOC writing. Do not to expose the unit to
any physical shock during UTOC writing.
❖ Use another MD.
Din Unlock
MD standard or is otherwise illegible.
❖ The signal at the digital input is not recognized by
❖ Use the all erase function and record the
MD from the beginning.
❖ Check the connections, and the output
TOC ERR^
the recorder.
❖ The disc is scratched or otherwise damaged.
mode of the source component.
❖ Use another MD.
SIO Error
❖ The TOC data cannot be read.
❖ The MD is out of standard.
❖ Internal communication in the unit has broken ❖ Turn power off then on again.
down.
Note: Error messages marked with an asterisk are followed by a number or other symbol.
<PRB1285>