Size & wide functions – Brother PT-330 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SIZE & WIDE FUNCTIONS
The character size can be adjusted using both the Size and Wide functions. Since the char
acter size that can be used depends on the width of the tape, the following table shows the
character sizes that can be used with each tape width.
Tape Widths
Sizes (in points)
1/4” (6 mm)
10, 13
3/8” (9 mm)
10, 13, 19
1/2” (12 mm)
10, 13, 19
3/4” (18 mm)
10, 13, 19, 26, 38
1”(24 mm)
10, 13, 19, 26, 38
The default Size setting is AUTO and the default Wide setting is OFF. The currently selected
Size and Wide settings are always shown by the indicators above the display.
With the AUTO Size setting, the machine compares your text with the width of the installed
tape and automatically adjusts the characters to the largest possible size. However, five
other point sizes are also available and each can be printed in wide characters.
Size
Settings
(in points)
Wide function OFF
Wide function ON
10
ABC
ABC
13
ABC
ABO
19
ABC
ABC
56