Brother PT-330 - Manual (Page 67)

FONT FUNCTION
With the Font function, you can choose from a variety of fonts for your text.
The following Font settings are available on the PT-330:
HELSINKI, BRUSSELS, TITLE SAN DIEGO, TITLE CALGARY and TITLE FLORIDA
The following Font settings are available on the PT-350:
HELSINKI, BRUSSELS, BERMUDA, TITLE SAN DIEGO, TITLE CALGARY, TITLE FLOR­
IDA, TITLE ISTANBUL and TITLE U.S.
The default Font setting is HELSINKI. The currently selected Font setting is always shown by
the Font indicators below the display.
The TITLE fonts are only available if the text consists of only one line and if 1/2"
(12-mm)-, 3/4" (18-mm)- or 1" (24-mm)-wide tape is installed. In addition, the text
will only be printed in capital letters and cannot be printed vertically or with other
character sizes.
Refer to Reference at the end of this section for samples of the available settings.
To change the Font setting:
O
Hold down and press once. The currently selected Font setting appears in
the display.
The Font indicators below the display also show the current Font setting.
O Keep held down and continue pressing until the desired setting appears in
the display and is shown by the Font indicators.
O Release to apply the selected Font setting to all of the characters in the text.
4Sil!#
To select the TITLE FLORIDA Font setting:
• Hold down Cc^dQ and press
A
A A
A
F O N T
H E L S I N K I
Style
Uoctertíne
Frame
Title F1 F2 F3 F4 FS Length
Font
64