Kenmore ULTRA WASH 665.16837 - Manual (Page 14)

(
C hina )
W entl ^
Use this cycle for china Use
and crystal. This cycle covered
uses a light wash and detergent
gentle dry. During the dispenser
heated dry, the heating section,
element cycles on and off.
Initial display time: 68 min
Soil
Level
Sensed
Wash Rinse Main
Wash
Rinse
or
Purge
Final
Heated
Rinse
Dry Cycle
Time
(min)
Water
Usage
(gal/L)
Heavy
• • • •
130°F
(54'C)
•
cycled
72* 8.6/32.7
Ught
• • •
130'F
(54X)
#
cycled
5S* 4.8/18.2
T ime
SAVER
Use this cycle for pre- Use
rinsed or lightly-soiled covered
loads. The sensor adds detergent
water and time, if needed, dispenser
for maximum cleaning. section.
No drying options are
available for this cycle.
Initial display time: 26 min
Soil
Level
Sensed
Wash Rinse Main
Wash
Purge Final
Heated
Rinse
Dry Cycle
Time
(min)
Water
Usage
(gal/L)
Heavy
• • • •
140*F
(60X)
30* 6.9/26.1
Light
• • •
140"F
(60*0
26* 4.8/18.2
( Q uick ^
V RINSE J
Use this rinse cycle for Do not use
rinsing dishes, glasses, detergent
and silverware that will with this
not be washed right away, cycle.
Initial display time: 10 min
Soil
Level
Sensed
Wash Rinse Main
Wash
Rinse Final
Heated
Rinse
Dry Cycle
Time
(min)
Water
Usage
(gal/L)
Heavy
• • 14 4.3/16>4
Ught
• 10 2.2/8.2
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
Canceling a Cycle
Anytime during a cycle, press
The dishwasher pauses for about 5 seconds. Then the
display shows
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
NOTE: A small amount of water remains in the dishwasher. This
is normal.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
Changing a Cycle or Setting
During the first fiil of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
After the first fill of a cycle
1. Press
The display shows
3.
4.
5.
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: if your dishwasher does not need draining, the light
turns off.
Check the detergent dispensers. They must be filled properly
for the new cycle.
Close the door.
Press a new cycle and/or options.
Press START.
14