Adding items during a cycle, To add items, Option selections – Kenmore ULTRA WASH 665.16837 User Manual

Page 15: Hi temp scrub, Sani rinse, Air dry, Lock on, Delay hours

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the main wash
section is stili ciosed, you can add items.

To add items

1. Lift up the door latch to stop the cycle. Wait for the spraying

action to stop before opening the door,

2. Open the door. If the main wash detergent dispenser is still

closed, add the item,

3. Close the door, but do not latch it. Wait 30 seconds for the air

in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.

4. Close the door firmly until it latches. The dishwasher resumes

the cycle after about a 5 second pause.

Option Selections

You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.

Select a different option if desired.

You can change an option anytime before the selected option

begins. For example, you can press an unheated drying option
any time before drying begins.

Press START to use the same cycle and option{s) as the previous

wash cycle.

NOTE:

If the last cycle you completed was a rinse cycle, when

you press Start, the dishwasher runs the last full wash cycle and

options.

Hi Temp Scrub

Select this option to heat the water during parts of the cycle. Hi

Temp Scrub heats the water to 145°F (63“C) in the main wash.

Heating the water helps improve washing results. Hi Temp Scrub
is useful when loads contain baked-on food.

This option adds heat, water and wash time to the cycle.

NOTE:

Hi Temp Scrub is an option with the Anti Bacterial, Pots

Pans and Normal Wash cycles,

Sani Rinse

Select this option to raise the water temperature in the final rinse
to approximately 155°F (68°C) for 10 minutes. Sani Rinse adds
heat and time to the cycle. In the Normal cycle this high-
temperature rinse sanitizes your dishes and glassware in
accordance with the NSF Protocol PI53 Sanitization and '
Cleaning Performance of Household Spray-Type Dishwashers.

[ S

ani

A

V RINSE

J

NOTE:

Anti Bacterial automatically uses this option. Sani Rinse is

an option with Pots Pans, Normal Wash and China Gentle.

Air Dry

Select this energy-saving option to dry without heat. Air drying is
useful when loads contain plastic dinnerware that may be
sensitive to high temperatures.

LOCK O

n

The dishes take longer to dry and some spotting can occur. For
best drying, use a liquid rinse aid. Some items (such as plastics)
may need towel drying.

NOTE:

Time Saver and Quick Rinse automatically use this

option. Air Dry is an option with all other cycles.

Lock On

Use the Lock to prevent your dishwasher from accidentally being
turned on. Use the Lock, also, to prevent accidental cycle or
option changes during a cycle.

L

ock

O

n

When LOCK ON is lit, all buttons are disabled.

NOTES:

The dishwasher door can be opened while the controls are

locked.

You can turn on the Lock while the dishwasher is running.

To turn on the Lock

Press and hold

(J)

LOCK O

n

for 4 seconds, LOCK ON glows.

If you press any pad while your dishwasher is locked, the light

flashes 3 times.

To turn off the Lock

Press and hold AIR DRY for 4 seconds. The light turns off.

Delay Hours

Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched.

You can delay the start of a cycle up to 12 hours.

The first time you use Delay Hours, you will see

showing a 1 hour delay.

15

Advertising