The bobbin, Wmbimq – Kenmore 1030 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WmBIMQ
THE BOBBIN
0
1.
Draw thread from spool through
bobbin winder tension disc as shown
in Fig. 1.
2.
Pull end of thread through hole in
bobbin
and
place
bobbin
onto
bobbin winder shaft with end of
thread coming from the top of the
bobbin,
fitting
the
notch
on
the
bobbin over locking stud on the
shaft as shown in Fig. 2.
3.
Push bobbin winder latch against
bobbin until it clicks.
4.
Release clutch by pulling hand wheel
or turning clutch knob as shown in
Fig. 4. Start machine, holding onto
end
of
thread.
When
bobbin
is
slightly filled, release end of thread.
5.
When
bobbin
is
full,
winding
mechanism stops.
6.
Push in hand wheel or turning clutch
knob to return to stitching position.
Remove bobbin.