Pioneer SX-209RDS User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING THE UNIT PRIOR TO
OPERATION
REGLAGE DU RECEPTEUR AVANT
LA MISE EN MARCHE
I
I
• Set the MAIN POWER switch on the rear panel to ON.
• Before operating the unit, be sure to set it as shown in fig. 12.
© Set the VOLUME control to the "'MIN" position.
© Press the POWER switch to the ON position.
© Press the SPEAKERS switch corresponding to the speaker
system to be used.
© Set the BALANCE control to the center position.
© Set the TAPE 2 MONITOR button to OFF (TAPE 2 indicator
goes off).
©
Placez l'interrupteur MAIN POWER qui est situé sur le panneau
arrière, sur la position ON.
Préparer l'unité comme indiqué sur la fig. 12 avant la mise en
marche du récepteur.
Placer la commande VOLUME sur la position "MIN".
Mettre l'interrupteur d'alimentation (POWER) en position sous
tension.
Appuyer sur la touche SPEAKERS correspondant au système
qui sera utilisé.
Placer la commande BALANCE dans la position centrale.
Placer la touche TAPE 2 MONITOR sur OFF (le voyant TAPE 2
s'éteint).
26
<XRD1002>
En/Fr