Clarion iDXZ775USB - Manual (Page 17)

Basic Operations
English
15
DXZ775USB
● Adjusting the bass
2-1. Select “ BASS ”.
3-1. Press the [ ] button.
3-2. Push the [ P.CH ] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “
0 ”).
3-3. Press the [ ] button to return to the
previous mode.
● Adjusting the treble
2-1. Select “ TREBLE ”.
3-1. Press the [ ] button.
3-2. Push the [ P.CH ] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “
0 ”).
3-3. Press the [ ] button to return to the
previous mode.
● Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select “ S RESTORER ”.
3-1. Push the [ P.CH ] button upward or
downward to adjust.
Each time you push the [ P.CH ] button, the
sound restorer changes in the following
order:
“ OFF ” ↔ “ 1 ” ↔ “ 2 ” ↔ “ 3 ”
∗
The factory default setting is “ OFF ”.\
Set this adjustment in accordance with the
music source used
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
● Adjusting the balance
2-1. Select “ BALANCE ”.
3-1. Push the [ P.CH ] button upward to
emphasize the sound from the right
speaker, push the button downward to
emphasize the sound from the left speaker.
∗
The factory default setting is “ 0 ”.
(Adjustment range: L12 to R12)
● Adjusting the fader
“ FADER ” can be adjusted only when the
speaker system is set to “ 2WAY ” or “ NORMAL ”.
2-1. Select “ FADER ”.
3-1. Push the [ P.CH ] button upward to
emphasize the sound from the front
speaker, push the button downward to
emphasize the sound from the rear
speaker.
∗ The factory default setting is “ 0 ”.
(Adjustment range: R12 to F12)
● Setting high pass filter
“HPF” can be adjusted only when the speaker
system is set to “NORMAL”.
2-1. Select “HPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting. Each time
you push the [P.CH] button, the setting
changes in the following order:
“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”
∗ The factory default setting is “THRGH”
(through).
● Setting low pass filter
“S-W LPF” can be adjusted only when the
speaker system is set to “NORMAL” .
∗ If subwoofer function is set to “ST” or “MONO”,
“S-W LPF” can be selected.
2-1. Select “S-W LPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting.
Each time you push the [P.CH] button, the
setting changes in the following order:
“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”
∗
The factory default setting is “THRGH”
(through).
DXZ775USB_EN.book 15 ページ ２００６年１２月２５日 月曜日 午前１１時３７分