Bosch SHU 3030 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IMPORTANT
Rinse agent, or a rinse aid, is used to dirninish water
spotting and to provide optimum drying results. Rinse
agent must be used at all times with the Bosch
dishwasher.
RINSE AGENT DISPENSER
The rinse agent dispenser is located next to the detergent
dispenser. See figure 12. Rinse agent is available in liquid
or solid form. Do not use the solid type of rinse agent in
the Bosch dishwasher.
To fill the rinse agent reservoir (refer to Figure 12):
•
Open the dishwasher door fully.
•
Open the cover of the rinse agent dispenser.
•
Add rinse agent to the reservoir until the clear level
indicator turns completely dark. The reservoir is full
when the level indicator is dark.
•
Close the cover of the rinse agent dispenser. Make
sure that it is firmly snapped closed.
RINSE AGENT DISPENSER REGULATOR
The rinse agent reservoir of the Bosch dishwasher is
provided with a regulator calibrated from 1 to 6. See
Figure 13. This regulator controls the amount of rinse
agent dispensed. The dishwasher leaves the factory
preset to 3'A. This has been chosen as the average setting,
however:
•
if you see streaks, it is recommended that the regulator
be turned to a lower number.
•
if water spots appear, it is recommended that the
regulator be turned to a higher number.
Figure 9.
TO ADJUST SETTING:
•
Open the cover of the rinse agent dispenser.
•
Turn the setting indicator to the desired setting. See
Figure 13.
•
Close the cover of the rinse agent dispenser. Make
sure that it is firmly snapped closed.
CYCLE SELECTION
The dishwasher will wash and dry the contents based on
cycle selection made. Refer to the CYCLE SELECTION
CHART, Table 2. The most appropriate cycle for the load
to be washed can be selected from this table by comparing
the load type and the amount and condition of the food on
the items to the charts recommendations.