Como instalar el tanque, Como encender el quemador principal, Comprobación de fugas – Coleman 4010003804 User Manual

Page 9: Troubleshooting, Advertencia, Español-5, English-8

Advertising
background image

Español-5

• Realice las pruebas de fuga al aire.
• Apague todas las llamas abiertas.
• NO compruebe NUNCA si hay fuga cuando

esté fumando.

• No use la estufa al aire libre hasta que la

conexión ha sido comprobada por fuga y no
halla fuga.

• PELIGRO DE QUEMADURA

• No deje nunca la estufa desaten-

dida cuando esté caliente o en
uso.

• Manténgala fuera del alcance de

los niños.

Como instalar el tanque

■ Inserte el generador por el orificio

grande al frente de la estufa y dentro
de la cámara de mezcla arriba del
quemador. Coloque las presillas del
tanque dentro de las ranuras al frente
de la estufa. (Fig. 10)

Fig. 10

Fig. 11

■ Gire los DEFLECTORES DE VIENTO
hacia afuera e inserte las PRESILLAS
METÁLICAS dentro de las ranuras en los
extremos de la estufa. (Fig. 11)

Como Encender el
Quemador Principal

NO LLENE O ENCIENDA NUNCA
LA ESTUFA DENTRO DE LA CASA,
CARAVANA O TIENDA DE CAMPAÑA

.

■ Cierre la VÁLVULA AUXILIAR (O

VÁLVULAS). Mueva LA PALANCA DE
ENCENDIDO hacia ARRIBA (UP).
(Fig. 12 & 13)

Fig. 13

Fig. 12

ADVERTENCIA

Comprobación

de Fugas

■ Asegúrese que la VALVULA DEL

COMBUSTIBLE está completamente
“CERRADA” (“OFF”).

■ COMPRUEBE SI HAY FUGAS de

una o más formas. Vea si hay o una
neblina de combustible o lo que
parece ser humedad de combustible
sobre las superficies. Escuche por
un siseo de gas escapándose. Huela
por olor de combustible. No use
nunca una llama. No la use si tiene
una fuga. (Fig. 9)

Fig. 9

COMPRUEBE

POR FUGAS

COMPRUEBE

POR FUGAS

COMPRUEBE

POR FUGAS

ADVERTENCIA

English-8

Troubleshooting

Symptom

Burner will not
light or flame self-
extinguished.

Burner will not
light or flame is
low or flame self-
extinguished.

Yellow flame.

Low heat.

Low heat.

Persistent small
yellow flame.

Persistent high
yellow flame.

Yellow smokey
flame.

Pump does not
pressurize the
liquid fuel
canister.

Intermittent yellow
flame after
extended use on
low heat setting.

Problem

Fuel tank empty.

Little or no pressure in fuel
tank.

Excess fuel in burner.

Generator tip plugged.

Faulty generator.

Faulty generator.

Failure in the fuel delivery
system.

Spider webs, insects, or
other obstruction in the
burner and air tube.

Pump seals are dry or
worn.

Flame requires adjustment.

Solution

Refill fuel tank with clean and
fresh Coleman

®

Liquid Fuel or

unleaded fuel.

Check that fuel cap is tight and
pump 30 strokes.

A yellow flame is normal until the
generator warms up. If yellow
flame persists, turn off stove,
allow flame to self-extinguish and
the stove to cool. If necessary,
invert stove to remove excess
liquid fuel from the burner. Follow
lighting instructions.

Turn LIGHTING LEVER up and
down several times to clean
generator tip. Be sure to use only
fresh and clean fuel.

Replace with a new generator.
This is a normal periodic
maintenance procedure. The
generator life is dependent on
the type of fuel used. Generator
life is extended by using clean
Coleman

®

Liquid Fuel.

Replace with a new generator.

May need to replace pump
assembly. Please contact
Consumer Service (see page 9).

Remove burner to inspect and
clean the burner and air tube.

Squirt a few drops of oil in the OIL
HOLE
in the pump cap. This will
keep the pump functioning properly
(Fig. 26). If this does not correct the
problem, replace the pump seals or
purchase a new pump assembly.

Adjust the flame to a slightly
higher level with the FUEL VALVE.

Advertising