Campbell Hausfeld TL103700AV - Manual (Page 2)

8 . Protect air lines from damage or
puncture .
9 . Never point an air tool at oneself or
any other person . Serious injury
could occur .
10 . Check air hoses for weak or worn
condition before each use . Make
sure all connections are secure .
Release all
pressure
from the system before
attempting to install, service,
relocate or perform any
maintenance.
11 . Keep all nuts, bolts and screws tight
and ensure equipment is in safe
working condition .
12 . Do not put hands near or under
moving parts .
Excessive exposure
to vibration,
working in awkward positions and
repetitive work motions can cause
injury to hands and arms. Stop using
any tool if discomfort, numbness,
tingling or pain occur and consult a
physician.
Never carry a tool
by the hose or pull
the hose to move the tool or a
compressor. Keep hoses away from
heat, oil and sharp edges. Replace any
hose that is damaged, weak or worn.
assembly
SySTEM SETUP
PLEASE REFER TO AIR TOOL AND SPRAY
GUN SET-UP (IN170102AV) FOR AIR
SYSTEM HOOK-UP INSTRUCTIONS .
Using fittings or air hoses which are too
small can create a pressure drop which
will result in a loss of power in the tool .
2
Operation
fIllING ThE CaNISTEr
(There are three methods to load the
air grease gun .)
METHOD 1 - CARTRIDGE (SEE FIGURE 1)
figure 1 - Cartridge replacement
1 . Unscrew the gun head from the
container tube .
2 . Pull the plunger handle completely
back and lock into place .
3 . Insert the open end of a grease
cartridge into the container tube
and completely push in the
cartridge .
4 . Remove the seal from the cartridge .
5 . Screw the gun head and container
tube back together .
6 . Press the plunger release to release
the plunger handle rod and push
the plunger handle back into the
container tube .
METHOD 2 - FILLER PUMP
(SEE FIGURE 2)
figure 2 - filler Pump Method
1 . Pull the plunger handle completely
back and lock into place .
2 . Insert the bulk fill valve into the
filler pump socket .
3 . Fill the container tube and
disconnect the grease gun from the
filler .
4 . Press the plunger release to release
the plunger handle rod and push
the plunger handle back into the
container tube .
METHOD 3 - BULK FILLING
(SEE FIGURE 3)
figure 3 - Bulk filling
1 . Unscrew the gun head from the
container tube .
2 . Pull the plunger handle back
approximately 2 to 3 inches and fill
this section of the container tube .
Repeat this process until the entire
container tube is filled . Be careful to
pack without air pockets .
3 . Screw the gun head and container
tube back together .
4 . Press the plunger release to release
the plunger handle rod and push
the plunger handle back into the
container tube .
Operating Instructions
www.chpower.com