Campbell Hausfeld JB004250 - Manual (Page 6)

Shank Nails Per Nails Per
Model # Length
Gauge
Finish Head Collation
Stick Box
FB180016AV 5/8 inch 18 Gauge Galvanized Brad /Brown Adhesive 100 1000
FB180025AV 1 inch 18 Gauge Galvanized Brad /Brown Adhesive 100 1000
FB180030AV 1-1/4 inch 18 Gauge Galvanized Brad /Brown Adhesive 100 1000
FB180040AV 1-1/2 inch 18 Gauge Galvanized Brad /Brown Adhesive 100 1000
FB180050AV 2 inch 18 Gauge Galvanized Brad /Brown Adhesive 100 1000
Fasteners
The following Campbell Hausfeld brad nails are available at local retail stores. For help locating any item, call customer ser-
vice at 1-800-543-6400. Campbell Hausfeld nails meet or exceed ASTM Standard F1667.
Interchange Information
Nails used in the JB004250 Brad Nailer will also work in: Bostitch T31-1, T29-30, BT-35, BT50, Duofast BB4440, Hitachi NT45A,
Paslode 2138-F40 , Porter Cable BN125, BN200, Sears 18409, 18424, and Senco SLP20, LS2, LS5.
Troubleshooting Guide
Stop using nailer immediately if any of the following problems occur. Serious personal injury
could result. Any repairs or replacements must be done by a Qualified Service Person or
Authorized Service Center.
Symptom Possible Cause(s) Corrective Action
Air leaking at trigger valve area O-Rings in trigger valve housing are damaged Replace O-Rings. Check operation of Work Contact
Element (WCE)
Air leaking between housing Loose screws in housing Tighten screws
and nose Damaged O-Rings Replace and lubricate O-rings
Damage to bumper Replace bumper
Air leaking between housing Loose screws Tighten screws
and cap
Nailer skips driving nail Worn bumper Replace bumper
Dirt in nose piece Clean drive channel
Dirt or damage prevent nails or pusher from Clean and check magazine
moving freely in magazine
Damaged pusher spring Replace spring
Inadequate air flow to nailer Check fitting, hose or compressor
Worn O-Ring on piston etc. Replace and lubricate O-rings
Damaged O-Ring on trigger valve Replace and lubricate O-rings
Air leaks Tighten screws and fittings
Cap gasket leaking Replace gasket
Nailer runs slow or has loss of power Nailer not lubricated sufficiently Lubricate nailer
Broken spring in cylinder cap Replace Spring
Exhaust port in cap is blocked Replace any damaged internal parts
Nails are jammed in nailer Guide on driver is worn Replace guide
Nails are not correct size Use only recommended nails
Nails are bent Replace with undamaged nails
Magazine or nose screws are loose Tighten screws
Driver is damaged Replace driver
Nails loaded incorrectly Review Loading/Unloading section in this manual
Air leaking at trigger valve stem O-Rings or seals are damaged Replace O-Rings or seals
6
Model JB004250 Operating Instructions
www.chpower.com