Kenwood CAW1170-09 - Manual (Page 4)

NOTES
Pi)- ■^)
Single DIN Mount Applications
1. Attach the left and right side brackets to the mam bracket. (See I ig.m
2. Insert pocket (part « into lower section of the mam frame
3. Attach left and right side brackets to the rear of the pocket using screws supplied
4 Insert DIN sleeve from your new radio into the upper section of the installation kit.
5 Depress the tabs from inside the sleeves opening upward, outward, and downward
to secure sleeve to the installation kit.
6. Install radio Into sleeve and lock into place.
7 Attach a rear support bracket to the rear of
the new radio and adjust as necessary to
attach to the rear support stud located o'
the back of the pocket using the small
Phillips screw supplied with kit.
NOTE: ISO tiiin ling (I ..) may be used in
place ol altei-maikei ladio’s lemovable trim ring V
KIT ASSEMBLY INSTRUCTIONS
single ISO Mount Applications
1 Attach the left and right side brackets to the main bracket (See Figure B pg 4)
2. Insert pocket ‘ into lower section of the main frame
3. Attach left and right side brackets to the rear of the pocket using screws supplied.
4. Attach (1) ISO Spacer to the inside of upper section on both Left & Right mounting
brackets as shown in Fig. A. (See note #2 pg. 4)
5. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides
of radio using screws provided with radio when possible or hardwarb included with kit.
6. Slide radio component lorward or backward tor desired look and tighten screws.
7. Attach a rear support bracket to the rear of the new radio a.d adjust as necessary to
aftach to the rear support stud located on the back of the pocket using the small
Phillips screw supplied with kit