Kenwood DP-2060 - Manual (Page 12)

Program m ed playback (PG M m ode)
Up to 20 tunes can be programmed jn the desired order and can be played.
■ Playing desired tracks in desired order (PGM mode)
Enter the PGM mode.
Press the | PROGRAM MODE| key.
IPGMI indicator lights up.
The SINGLE TIME display .changes to
TOTAL TIME display.
2 Program desired tracks in desired order.
(c
3
^3
b
Example
To program track Nos. 2, 5 and 25:
[g[5l Ffol
Indicator
blinks, r
IP p program {P-No.) is
i displayed for a few
gг..
I The total time of
the selected track
I will be displayed.
» Up to 20 tracks can be programmed. FULL is displayed if
you attempt to program the 21st track.
» If you made a mistake, press thelCLEA^key and seiect the
correct track.
» Tracks can be also programmed by reading the disc label
while the disc tray is open.
» The time information is not displayed if a track No. of 44 or
more is programmed.
3 Start playback.
• Tracks are played in the order they are programmed (P-No.).
• If one of the skip keys ( | o r | ] is pressed during
programmed playback, the track being played is skipped in
the forward or reverse direction.
To check the programmed contents
IP.C.1 Indicator lights up.
» Every time the ICHECKI key is pressed, the track No. and the
contents which were programmed (P-No,l are displayed in the
order of programming.
» The previous display will resume in a few seconds.
To resume normal playback
PROGRAM
iPGiVll indicator goes off.
» The playback in the order of the track Nos. on CD will start after
the track which is being played.
To check the time of each track on the disc
In the program mode, when the disc is stopped, the time of each
track on the disc can be checked by pressing the skip keys]^»n|.
» The previous display will resume in a few seconds.
12 DP-2OeO^DP-lD80 iEn>