Kenwood DPC-341 - Manual (Page 2)

Aii Caution: Read this page carefully to
_______ ensure safe operation.
For the U.S.A. and Canada
Important!
Units shipped to the U.S.A. and Canada are designed for operation
on 120 volts AC only.
CAUTION: TOPREVENTELECTRICSHOCKDONOTUSE
THE AC PLUG WITH AN EXTENSION CORD. RECEPTACLE OR
OTHER OUTLET UNLESSTHEBLADES CAN BE FULLY INSERTED
TO PREVENT BLADE EXPOSURE.
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Cha nges or modif ications to this equipment may cause
harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose
the authority to operate this equipment if an unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment may cause harmful interference to radio communications, if it is not installed
and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the Interference by one
or more of the foliowing measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
For CANADA
DOC REGULATION
"This digital apparatus does not exceed the CLASS B limits for radio noise emissions from digital apparatus as set
out in the radio interference regulations of the Canadian Department of Communications.*"
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
The marking of products using lasers
(Except for some areas).
CLASSI
LASER PRODUCT
This label is attached to the bottom panel and says that the
component uses laser beams that have been dassiflad as Class 1.
It means tiiat the unit is utilizing laser beams that are of a weaker
class. There is no danger of hazardous radiation outside the unit.
WARNING NOTICE:
IN MOST CASES IT IS AN INFRINGEMENT OF COPY­
RIGHT TO MAKE COPIES OF TAPES OR DISCS WITH­
OUT THE PERMISSION OFTHE COPYRIGHT OWNERS.
ANYONE WISHING TO COPY COMMERCIALLY AVAIL­
ABLE TAPES OR DISCS SHOULD CONTACT THE ME­
CHANICAL COPYRIGHT PROTECTION SOCIETY LIM­
ITED OR THE PERFORMING RIGHTS SOCIETY LIM­
ITED,