Instauation, How to use the faceplate fastening screw, Caution – Kenwood KRC-601 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
InstaUation
C
g
v*
JO
15
•f-»
</>
To remove the unit.
1. Remove the Screws with washer (M4 x
8) holding on the back panel.
2. Insert the removal tools deep into the
slots of the unit.
3. Push the tools down and puli them
toward you until the set is drawn out
halfway.
How to use the faceplate
fastening screw.
When you want to fasten the faceplate to
the main unit so that they cannot be
separated, attach the provided machine
screw (([) 4 X 16 mm) into the screw hole
shown in the illustration below.
^CAUTION
Be sure to attach the machine screw (<|>
4 x 1 6 mm) to the specified screw hole.
If it is attached to other screw hole, it
will contact the mechanical parts inside
the unit and cause damage to them.
Never insert the machine screw (<(> 4 x
16 mm) into other screw hole than
specified.
4. Take the set out by hand, being careful
not to drop it.
44
English