Priority scan, Delay, Priority scan delay – Uniden UBC220XLT User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To access a specrfic channel:
1,
Press®.
2.
Enter the channel number using the numeric keys.
3.
Press @ again.
Priority Scan
The UBC 220XLT has 10 Priority Channels, 1 per Bank.
Initially, these are the tirsi channel in each Bank. (e.g.
Channel 1, Channel 21, Channel 41, and so on.) The scanner
checks the Priority Channel(s) every 2 seconds during the
Scan cycle. If a transmission is received, the scanner will stop
at that channel. If the Priority Channel in any Bank is “Locked
Out™, it will be skipped during scanning.
You can move the Priority to any other channel in a Bank as
follows:
1
.
Go directly to that channel using any of the methods
described above.
2
.
Press and hold ( Pfll } for at least 2 seconds. You will
hear a “beep”, and P will appear on the display to the
left of the new channel number. That channel will now
be the Priority Channel for that Bank. (The P will no
longer appear for the previous Priority Channel.)
To activate Priority Scan, press (PHI). The PRI indicator will
appear at the bottom of the display. To deactivate Priority
Scan, press ( PRI ) again. The PRI indicator will disappear from
the bottom of the display.
Delay
Normally the scanner will resume scanning when a
transmission stops. If you want to remain on a channel until a
responding transmission is received, activate the DELAY
feature. This feature can be active in SCAN, SEARCH,
and WEATHER Modes
1
.
Press [PEUiY). The DLY indicator appears at the bottom
of the display. The scanner will now pause 2 seconds
after transmission stops before resuming scanning.
2
.
Press (EEUY) again to deactivate Delay. The DLY
indicator disappears from the bottom of the display.
I
17