Kenwood KR-1000B - Manual (Page 13)

FM presetting
1 Set the TUNE pushbutton to AUTO.
2 Push the UP or DOWN key to tune to the desired broad­
cast.
3 Adjust the volume with the UP or DOWN VOLUME key to
adjust to the desired sound level.
4 Push the MEMORY key; the word MEMORY will light up
in the frequency display.
5 Push the STATIONS key marked 1 to store the received
station while the MEMORY indicator is still lit.
6 Repeat steps 2 through 5 to store the rest of the desired
broadcasting stations with the STATIONS keys marked 2
through 6.
=Sr
FM 3E.B
SIGNAL
IMEWORYI
Be sure to preset a broadcast by
pressing one of the STATIONS keys
while the word MEMORY is on.
To modify the above signal flowchart to the one shown
below, press the LOUDNESS key and the OFF (G. E) key in
any order.
I SPEAKER A
-o-
r«c1
To store the above signal flowchart, press the MEMORY key
then the key marked M-2.
To add speaker B to the above signal flowchart, simply press
the SPEAKERS key marked B. Then you obtain the signal
flowchart shown below.
1 SPtAKtH A
I SPtAKiHB~|— — ■
[wc]
Press the MEMORY key and the key marked M-3 to store
the above signal flowchart into the memory.
To insert the graphic equalizer into the above signal path,
press the SOURCE (G. E) key to obtain the signal flowchart
shown on the following page.
I SPtAKtHA ~l~|
I SPEAKER B I— - - - - - ■
Ice owl |«tc|
Press the MEMORY key and the key marked M-4 to store it.
AM presetting
1 Push the AM key of INPUT SELECTOR to modify the sig­
nal flowchart used for FM presetting for the reception of
AM broadcasts.
2 Repeat steps 2 through 6 described in the preceding
"FM PRESETTING" to store the desired six AM broad­
casting stations.
How to draw signal flowcharts
With this keyboard, drawing any desired signal flowcharts is
easily done by a series of keystrokes. To load the whole sig­
nal flowchart drawn on the display into the memory, press
the MEMORY key of PROGRAM MODE COMMANDER then
one of the keys marked M-1 through M-4.
Four signal flowcharts can be stored with this keyboard by
repeating the procedure.
Before drawing the signal flowchart, summon the original
contents (factory defined signal flowchart), shown below by
pressing the M-1 key.
I SPEAKER A h-| I— [I Q—I pHOBAPHicIo)-^
|G£0>T| Intel
If the above signal flowchart is what you want, press the
MEMORY key then the key marked M-1 to store it.
These four signal flowcharts stored in the memory remain
intact unless other new signal flowcharts are loaded by simi­
lar procedures as seen in the above examples. In other
words, no matter how you modify the signal flowchart
stored in M-4, for example, by pushing the keys, the stored
signal flowchart will be displayed any time when the M-4
key is pressed.
How to combine signal flowchart and preset
station
To combine FM (AM) stations, proceed as follows:
1 Press one of the PROGRAM MODE COMMANDER keys
marked M-1 through M-4 to summon the signal flow­
chart set to FM (AM) input.
2 Press one of the STATIONS keys marked 1 through 6 to
receive the desired broadcast.
3 Press the MEMORY key of the PROGRAM MODE
COMMANDER then the key used in the stop 1 to store
the combination of the signal flowchart and FM (AM) sta­
tion indicated on the display.
4 Repeat steps 1 through 3 to store other combinations.
KR-IOOOB(K) 13