Kenwood KR-1000B - Manual (Page 20)

Continued from the preceeding page:
If you want to change the shut-off time from 30 to 20 min­
utes, for example, press the MINUTE key to indicate 20 on
the timer display and press the AUTO OFF (ENTER) key.
Proceed as follows:
Key baord
CLOCK THKOWOH AUTO OPT
^iraoi CMiCK -1
SA4TT LOCK AWTO MANUAL CLCA*
□ □ □ □
PtCSIT VOL
LIVQ. UT
□
OAT KOU* MNWTI
□ □ S-
S » t
a □ □
4 LAST MOM OPP
□ □ □ ■
□ □ Q-
These numbers refer
to the step numbers
Operating instructions
AM/FM reception
With this receiver, three different ways of tuning are possi­
ble: automatic tuning; manual tuning and tuning with preset
keys.
For initial setup, press the POWER key to turn the unit on
and arrange the signal flowchart on the display, if needed, in
order to connect the tuner section by pressing the INPUT
SELECTOR key marked FM or AM then proceed as follows:
Preset tuning
1. Press one of the STATIONS keys corresponding to the re­
quired broadcast station.
Six broadcast stations have been preset by the proce­
dures described in FM/AM PRESETTING on page 13.
2. Adjust to the required volume with the VOLUME keys.
3. When adjusting the tone, press the G.E. key marked
SOURCE and depress the upper or lower pushbuttons of
the GRAPHIC EQUALIZER according to your require­
ments.
When changing the shut-off time from 30 to 20
minutes
O AUTO OFF A-OFF
O MINUTE to set a - off ^/7--'7 9* l 7 / "
A-OFF p [J (Stored) О AUTO OFF
(ENTER)
A-OFF {
CLOCK
jj ¡J (Shut off)
Once the desired shut-off time is stored in the memory the
instruction remains intact unless a new instruction is stored
in the memory by pushing the AUTO OFF (ENTER) key. So,
when executing the instruction by pushing the AUTO OFF
key, the display shows the set minutes. However, discon­
necting the power plug or power failure clears the instruc­
tions stored in the memory except for original contents. The
first time AUTO OFF key is set after connecting the power,
the display shows 59 minutes and this factory defined in­
struction is executed each time until a new instruction is
stored.
Auto tuning
1. Set the TUNE pushbutton to AUTO (out).
2. Press the TUNING key marked UP or DOWN.
The frequency in the display increases or decreases until
the next station is received.
3. Adjust to the required volume with the VOLUME keys.
4. When adjusting the tone, press the G.E. key marked
SOURCE and depress the upper or lower pushbuttons of
the GRAPHIC EQUALIZER according to your require­
ments.
Extended use of auto tuning
Six broadcast stations are preset in the STATIONS keys
marked 1 through 6, which are referred to by the letters A
through F shown in the figure below.
+
Frequency range
I I
HFM
ЧАМ
(A) (B) (C) (D)
- Stored -
(E) (F)
I. Л Л
Stations A through F are located over the whole range, at
approximately the same interval.
Proceed as follows:
1. Set the TUNE pushbutton to A1.JTO (out).
2. Press the STATIONS key marked 4 or 5 to receive the
preset station D or E.
3. Press the TUNING key marked UP or DOWN to search for
broadcasts between the two preset stations.
4. To search for broadcasts between the preset stations A
and B, press the STATIONS key marked 1 or 2 and pro­
ceed from step 3.
This procedure gives a quick access to broadcasts.
20 KR-IOOOB(K)