Vermont Casting Jefferson JUVSR & JUVSM 3095 - Manual (Page 12)

12 12
Vermont Castings Jefferson Vent Free Gas Heater
20003447
Install the Stove Front
The Front Plate attaches to the stove by four steel tabs
that engage with corresponding cast ribs on the sides
and bottom of the stove body. Position the Front about
3” down from stove top and lift the plate to engage the
upper tabs behind the adjacent ribs on the sides. (Fig.
17) Then lower the plate into position, so that the
lower tabs engage with the corresponding ribs at the
bottom. (Fig. 18)
When properly installed, the bottom of the Stove Front
cannot be pulled away from the sides without also lifting
it.
Stove Side
Side Rib
Front Tab
Stove Front
ST279
Fig. 180 Engage with side ribs.
Lava Rock
ST224
Fig. 15 Install lava rock and upper logs.
4
5
ST225
Fig. 16 Completed log installation.
3”
Upper Tabs
C o n t r o l
Door
Lower Tabs
Engage Ribs in
Bottom
ST725
Fig. 17 Install stove front.