Vermont Casting Jefferson JUVSR & JUVSM 3095 - Manual (Page 9)

9
Vermont Castings Jefferson Vent Free Gas Heater
20003447
Unpack the Stove
Remove the stove assembly from the shipping carton
and inspect it for loose or damaged parts. Do not install
this appliance if any parts are loose or if there is any
visual or suspected damage resulting from shipping or
handling. Report damage to your dealer/distributor
immediately. The log set is packaged in the box
shipped inside the firebox.
To remove the packaged log set from the firebox:
• Lift the stove front up and then swing the bottom out
and away to disengage it from the stove body. (Fig. 4)
Cut the wire tie securing the screen.
• Remove the screen frame. (Fig. 5)
• Remove box and set aside.
Contact your dealer if the burner is loose or damaged in
any way.
ST229b
Fig. 4 Remove stove front.
ST208b
Fig. 5 Lift screen from firebox.
Screen Hooks
Assembly Procedures
WARNING
Failure to position the parts in accordance with these
diagrams or failure to use only parts specifically
approved for use with this heater may result in
property damage or personal injury.
Optional Fan Kit Installation (2960/FK28)
1. Attach the fan to the rear shroud by engaging the
upper flange of the fan skirt under the lower edge of the
shroud and secure the skirt with the four screws and
one star washer provided. (Fig. 6,7)
ST241
Fig. 7 Correct position of fan skirt installation.
Upper
Flange
To Control
Valve
ST240
Fig. 6 Place upper flange behind lower edge of shroud.
Star Washer
CAUTION
Porcelain enamelled surfaces are fragile. Handle
porcelain enamelled castings tenderly. Familiarize
yourself with the assembly steps before you begin
and proceed with deliberation and care. If possible,
have assistance available.
Place enamelled castings on a soft, cushioned
surface until you are ready to assembly.
Avoid contact between the castings and other hard
surfaces or objects.