Programming channels, Programming by manual entry, Programminjg channels – Uniden UBC 120XLT User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming Channels
Before you can scan, you must program the channels within a
bank. You can store one frequency per channel, up to 100
channels.
Note: If appears on the display (keypad Locked),
unlock the keypad by pressing and ho/d/ng (T^until
ir* disappears and you hear two beeps.
There are two ways to program a channel:
■
Manually select a channel and frequency, using the
numeric keypad.
■
Search a band to find an active frequency, and then
directly store it into a selected channel. {See the
Search section, page 21.)
Programming By Manual Entry
1. Select a frequency.
Example: Program 125,2500 MHz into Channel 18.
2. Make sure the scanner is in the SCAN Mode. If it is in
the SRCH Mode, press @l.
3. Press @ to stop scanning.
4. Press (TXD@ 9 ° C h a n n e l 18.
5.
Enter the frequency number using the numeric keypad,
(Be sure to include the decimal point.) As soon as you
enter the first digit of the frequency, the channel number
begins to blink.
© © ® ® © ©•
if you make a mistake and want to clear the entry, press
twice and re-enter the frequency,
14