Location, Cleaning, Repairs – Uniden UBC 120XLT User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6
. Insert the Battery
Pack by placing the
side with the label in
the case first. Make
sure it is seated
within the case before
replacing the Battery
Cover.
7. Replace the Battery
Cover by putting the
two tabs in the
corresponding
opening and sliding it
upward until it locks in
place.
Location
■
If strong interference or electrical noise is received,
relocate the scanner or its antenna away from the
source of the noise. A higher elevation, if possible, may
provide better reception.
■
Do not use the scanner in high-moisture environments
such as the kitchen or bathroom.
■
Avoid placing the unit in direct sunlight or near heating
elements or vents.
I
Cleaning
■
Disconnect the power to the unit before cleaning.
■
Clean the outside of the scanner with a mild detergent.
■
To prevent scratches, do not use abrasive cleaners or
solvents. Be careful not to rub the LCD window.
■
Do not use excessive amounts of water.
Repairs
Do not attempt any repair. The scanner contains no
serviceable parts. Contact the Uniden Service Division or
take it to a qualified repair technician.
23