Kenwood KDC-DAB43U - Manual (Page 2)

Match thecontact tabsof the amplifier©
with the A on the antenna film © and
stick.
■ Do not touch the feeder terminal or the
sticky surface (adhesive side) of the
amplifier.
Amplifier©
Interior part
Earth sheet
9 Route the antenna cable down the pillar and
across the inside of the dash, to the head-unit
location
■ Use cable ties to secure the antenna cable to
the pillar at several locations.
Notes
8 Remove the film covering the earth sheet
and stick the earth sheet on to the metal
part of the windscreen pillar.
Provide sufficient leeway for the earth
sheet so that it does not interfere with the
interior parts (front pillar cover).
Also take care that the interior parts do not
interfere with the amplifier ©.
Front glass
y Front pillar
Take the following precautions when routing
the antenna cable down the front pillar if
an air bag is installed.
Install the Amplifier part of the antenna cable
behind or away from an air bag or it's wiring
so that it does not interfere with the vehicles
safety systems.
The front pillar cover is secured with
a special dip which may need to be
replaced when the front pillar cover is
removed.
Contact your vehicle dealer for details
on replacing the front pillar cover and
availability of replacement parts.
10 Final connection 8> antenna start-up
Plug DAB Antenna into botom
left hand port as shown above.
Select the DAB antenna power
Set "INITIAL SET" > "DAB ANT POWER" to "ON"
in STANDBY mode.
Push and hold the DAB button to auto tune all
available DAB stations