Uniden BC 50XL - Manual (Page 8)

i_C-_____________ C-C_r/--''
I O
C D 3 U
I
The display will show ihe frequencry one digit at a time and then show channel l.
CHANNEL
2. To program 471.2375 into channel 5:
a
MANUAL
]
ШИ□□Шаши ш
(Rounded oh (о 3 places)
REVIEW
]
The display will show:
U 1 } ^
3 3 7_C
I " / " i------------------
C-Jr^
/ 3
CHANNEL
If you attempi to enter a frequency outside the range of the Uniden' Bearcat'
50XL, the display will show an " f If this ever happens, simply enter Ihe
correct number, fou may omil the decimal point when entering frequencies
in the VHP high band (136-174 MHz) and UHP (406-512 WHz )
The Uniden' Bearcat' 50XL has been designed to automatically enter trail­
ing zeros on Ihese bands. On LOW 8AND (2^54 MHz}, YOU MUST PRtSS
ТНЁ DECiMAL POm or an ' f will appear.
When first lurned on after purchase or afler batteries have been removed, a
tesi frequency will be found in each of Ihe ohannets. When you program your
own frequencies, these test frequencies will be erased until power is completely
lost.
SQUELCH
The squelch function controls the sensitivity of the receiver. It adjusis the level
at which the scan mode will stop lo receive a transmission on any frequency.
Rotate the "SQUELCH" control clockwise until you hear background noise
and then turn it i3ack counlerolpckwise until the noise is silenced. This will set
the scanner to receive any transmission above the level of background noise.
You can adjust the squelch level to pick up more distant signals by turning
it clockwise, or less distant signals by turning it back.
MANUAL CHANNEL SELECTION
If you wish to select a channel тапиаИуг press and release Ihe [ m ANUA^
key unlil that channel number appears in the display You can also press the
channel number, then the Гмд^иА|Г| key to directly access ihai channel.