Installation, Non-japanese cars, Japanese cars – Kenwood KDC-MP408U User Manual
Page 20: Removing the hard rubber frame, Removing the unit
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
non-Japanese cars
Metal mounting strap
(commercially available)
(commercially available)
Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
Japanese cars
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
rennove the two locks on the upper level.
Upper the franne and pull it forward as shown in
the figure.
Removal tool
2
When the upper level is rennoved, remove the
lower two locations.
The frame can be removed from the bottom side in the
same manner.
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2
Remove the screw (M4 x 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
4
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
Screw (M4X8)
Accessory®...for Toyota car
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands, being
careful not to drop it.
20
I
KDC-X492/KDC-MP438U/KDC-MP408U/KDC-MP338