In case of difficulty, Amplifier, Tuner – Kenwood KRF-V5560D User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
In case of difficulty
Amplifier
- - Sf»ptoin
Cans# '' ......... .<1
Remedy -
No sound from the speakers.
• The speaker cords are disconnected.
• VOLUME IS set to the minimum position.
• MUTE IS ON
• The SPEAKERS switches are set to OFF.
• Connect them properly referring to "Connect
ing the speakers" -OS
• Adjust the volume to a proper level.
• Turn OFF the MUTE. -!2a]
• Set the SPEAKERS switch to ON. -Cg]
The standby indicator blinks and sound is
not output.
• Speaker cords are short-circuited.
• Turn the power off. eliminate the short-circuit
ing, then turn on the power again.
Sound is not output from one of the speak
ers.
• The speaker cord is disconnected.
•Connect it properly referring to "Connecting
the speakers". ~l3£l
Sound is not output from the surround
speakers and / or the center speaker, or their
sound is very small.
• The surround speaker cords and/or the center
speaker cord is disconnected.
• A surround mode has not been engaged.
• The surround and/or center volume controls
are set to the minimum level.
• Connect it properly referring to "Connecting
the speakers". -QJ)
• Select a surround mode.
• Adjust the speaker levels using the test tone.
A humming noise is generated when the
PHONO input selector is selected.
• The audio cord from the record player is not
connected to the PHONO jacks.
• The record player is not grounded
• Insert the audio cord plugs securely Into the
PHONO jacks,
• Connect the grounding wire to the GND termi
nal on the rear panel.
When playing a Dolby Digital source signal
using a DVD player, the sound is cut off soon
after it starts.
• There are many possible causes for this prob
lem, depending on the type of DVD player
used.
• Set the input mode to digital manual before
starting playback of the Dolby Digital source.
No sound is produced during playback from
a DVD player.
• The input mode is set to digital manual.
• Press the INPUT MODE key to select to digital
auto mode, -tj]
A video source cannot be recorded normally.
• The software is copy-guarded.
• Copy-guarded video software cannot be re
corded.
Tuner
Symptom T „, , t«: 1 fj . -, ■ ■ ' ■ . _ ........................................... TiliilP
Remedy
Radio stations cannot be received.
• No antenna is connected.
• The broadcast band is not set properly,
•The frequency of the desired station is not
tuned
• Connect an antenna. -132
• Set the broadcast band properly.
• Tune the frequency of the desired station.
-a
Interference.
• Noise due to ignition noise from an automo
bile.
• Noise due to interference from an electric
appliance
• Noise due to a nearby TV set
• Install the outdoor antenna away from the
road.
• Turn off the power to the appliance.
• Install the receiver farther away from the TV.
A station which was preset cannot be re
ceived by pressing the corresponding nu
meric key.
• The preset station belongs to a frequency that
cannot be received.
• The preset memory was cleared because the
power cord had been unplugged for a long
period of time
• Preset a station with a receivable frequency.
• Preset the station again
33
EN