System connections, About the system control connections, About the system control operations – Kenwood BJV140Z User Manual
Page 11: Note on connection of optical-fiber cable, System
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
System
connections
1Q5DMD IE"'
11
About the system control connections
About the system control connections
Connecting system control cords after connecting a Kenwood audio component system lets you take advantage of
convenient system control operations.
There are two Kenwoood system control modes. Make connections according to the groups of terminal symbols shown
below.
[XS8] Mode : lets you combine
JCll.
IXS, and
XS8
terminals
[SL16] Mode : for [SL16] terminals only
This unit is SLÏB compatible.
You can connect this unit via system control if all other equipment using system control connections are set to the [SL16]
mode.
1.
[SL1 61 еаи'отеп: ca'^iot oe соглопес wtn [XRi, [XS], эла [XS8] eauipnient to'" system
operat ors if your eau'pment consists uf tins "uno of carnuinatiuii, olease do not oonnect
any system control co^ds. Even without system control coros. normal operations can oe
carried out w tnout affecting oerfcmiance.
2 if your amp
0
' receiver does not nave a system control term пае do not connect any syste"'.
control cords to the system conrol terminals on the other components.
3 Do not connect system corool cords to any components otne" than those specified by
Kehvyood U may cause a madunef on ana oamage yom eouioment
4. Besurethesystemcontrolplugsareinsededai the way m to the system control terminais
About the system control operations
Remote Control
Lets you operate this unit with the system remote supplied with the amp or receiver.
Automatic Operation
Automatically switches the input selector on the amp or receiver when you start playback from this unit.
Synchronized Recording
When recording a CD after setting the amplifier's input selector to CD, starting playback on the CD player allows to
start recording automatically in an interlocked operation.
• Do nci operate tne CD player during recording of a digital souxe other than CD. otherwise malfunction may occon
Note on connection of optical-fiber cable
The optical-fiber cable is designed for use in the connection
of the CD player (optional). The digital signal transmission
makes it possible to record the high-quality sound of CDs
without degradation.
• Insert the optical-fiber cable straight -nto tne connector until it clicks.
• Be sure to attach the protection cap when tne connector is not used.
• Never oend m Dundle the ooticahfiber cable.
• An of the commercially-avaiiable optical fiber cables cannot be used
w'lth these units. If there is an optical fiber cable which cannot be
connected to you'" con-tponent, please consult your dealer or nearest
KENWOOD agent.