Uniden UBC60XLT User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONDITION
SUGGESTION
Scan doesn't stop.
Adjust the Squelch setting. It
may be too high.
Check the antenna connection.
Make sure the antenna is in a
vertical position.
Reception may be poor. See
above for suggestions.
It is possible that none of the
programmed frequencies are
active at the time.
Scan doesn’t start.
Make sure there are some
programmed channels.
The scanner may be in Manual
mode. Press @ to begin
scanning.
The scanner may be stopped on
a weather frequency. Press @
to begin scanning.
Adjust the Squelch setting. It
may be too low.
All the channels may be locked
out. Turn off Lockout for the
channels you want to scan.
Keypad won't work.
Check the Keylock. Make sure
Keylock is off before
programming or locking out
channels.
I
H you sUII cannot get satisfactory results and want additional
information, or to return the unit for sen/ice, please call or write
the Uniden Customer Service Division. The address and
phone number are listed in the Warranty (at the end of this
manual).
22