Kenwood TM-441A - Manual (Page 38)

5. Only a signal with the proper CTCSS tone (if the TSU-
6 is installed ) will initiate recording. If no tone unit is
installed the recording will start whenever squelch
opens. (The alert function will not sound an alarm.)
The CTCSS, DTSS (only reception is possible even if
the DTMF unit is not installed), and paging functions
are available.
6. If the squelch is closed during recording in the
automatic recording mode, recording will finish at
the current phrase, and the next phrase will be
awaited even if there is recording time remaining.
(Recording will not be possible if there is no empty
phrase.
OLock canceling
If the third digit of the display is “1“, recording is
locked, and a new signal cannot be recorded in the
same phrase. If the third digit is “2“, recording and
playback are locked, and a new signal cannot be
recorded in the phrase and the phrase cannot be played
back.
To cancel the lock, press the REV/STEP key so that the
third digit become zero(O).
5-9-7 External Control of the DRS Function
(DTMF control mode)
The DRS function can be remotely controlled by an
external DTMF signal.
5-9-8 ID Number Seting
Select a four-digit number from 0000 to 9999.
1. Press the F key for longer than 1 second, then press
the DR/DT key while the F indicator is flashing. The
DRS setting mode will be entered and the DRS
indicator will light.
2. Press the MHz / LOCK key. Four digits will be
displayed, and the first digit will flash.
------ ■ ---------------»WOOD
(d v 9. i
. '.
^ 'n.nnn
n ..
3. Set the first digit with the tuning control, then press
the MHz/LOCK key.
The second digit will flash.
38