Kenwood SA 600 - Manual (Page 3)

Installation of the Microwave Cooker
WARNING -THIS APPLIANCE MUST BE EARTHED.
Important
This microwave cooker has been designed for use in a domestic househoid. Therefore the
guarantee supplied with this appliance may be invalidated if it has been used in a commercial
or catering application.
INSTALLATION
If this appliance is fitted with a non-rewireable plug for which your socket is unsuitable the plug
should be cut off and an appropriate plug fitted. The removed plug should be disposed of as
insertion of the plug into a 13 A socket is likely to cause an electrical hazard. If it is necessary
to change the fuse in a non-rewireable plug the fuse cover must be refitted. If the fuse cover
is lost or damaged the plug must not be used until a replacement is obtained. Replacement
fuse covers are available from Kenwood for Kitchens Ltd., Service Division, Limberline Road,
Hilsea, Portsmouth, Hants. Tel: 0705 664466. It is important that the colour of the replacement
fuse cover corresponds with the coloured insert or as embossed in words on the base of the
plug.
Important
The wires in the mains lead are coloured in accordance with the following code:
Green-and-yellow:
Blue:
Brown:
Earth
Neutral
Live
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal which is
marked with the letter ‘E’ or by the ‘Earth’ symbol or coloured green or coloured green
and yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the
letter ‘N’ or coloured black. The wire which is coloured brown must be connected to the
terminal which is marked with the letter ‘L’ or coloured red.
The appliance must be protected by a 13 A ASTA approved (BS1362) fuse if a 13 A (BS1363)
plug or a non-rewireable plug is used or if any other type of plug is used by a 15 A fuse either
in the plug or adaptor or at the distribution board.
We recommend that the installation be checked by a qualified electrician who can ensure that
the appliance is operating satisfactorily and that it has not been damaged in transit.
Ensure that there are no restrictions preventing air circulation to the cooling vents.
S&f o'ty *
DO NOT OPERATE THE COOKER WHEN EMPTY - SEE PAGE 10 PARA. 2
Ensure that the door seal is clean before use, clean door seal surfaces with a warm soapy
cloth. Do not use abrasives. Do not operate the oven if the door seal is damaged. For service
contact the nearest Service Depot. It is dangerous for anyone other than a service technician
trained by Kenwood for Kitchens Ltd., to perform repair service on this appliance.
See Operation Checks (page 5) and Service Call Check (page 5).
This appliance complies with the Radio Interference requirements of EEC Directive 76/889/
EEC.