Kenwood SPECTRUM 850 AV - Manual (Page 50)

the Dolby Pro. Logic mode). , . . _ ‘ • Check for interference from automobiles. If so, install
The STANDBY light blinks, but there is no
sound
the outd.o.or antenna away from roads,..
None of the functions operate, or the display
• Check that the speaker cables aren’t short-drxuited“ - shows wrong information
that is, the (+) and (-) wires, .aren’t touching each, • Reset.your unit’s microcomputer by unplugging the’ ...
other. If they are, separate, the wires. . power cord.fromtheeJeçtrica!.outlet and plugging it
A hum when you select the PHONO input
• Check that the audio cables are plugged .securely into
back in while, holding down, the MEMORY button. ..
the PHONO Jacks.. " :r ' “' , w
.
•. Check that the turntable is.grounded on .the rear - .
CD player
panel. The ground wire should be connected to the .
screw ! abé led .GND/ . ’ . ' Power light doesn’t come on
None of the functions operate, or the display
• Check that the power cord is properly plugged into . ^
the electrical outlet .on the back of the power ampli-'
shows wrong information fier.,
• Reset your unit’s microcomputer by unplugging the
power .cord from the electricaLoutlet and plugging it Player doesn’t play a loaded CD
back in while holding down the POWER .button. ...... • Check that the CD is loaded right-side up.
• Checkthat the CD.isn’t cracked ordirty. ■;
Tuner • There may' be condensation on the fens. Leave the .
player on forat least 1 hour before usinait ' .
You can’t receive radio stations No sound
• Check that the station .is tuned in properly. . . • Check that the CD is loaded properly.
• Checkthat the TUNER input is selected. .... • Checkthat the CD isn’t cracked or dirty., , .
• Checkthat the antenna is connected, properly. • Checkthat the.PLAY mode is,active (the
■ PLAY/PAUSE light should be ON).
You can’t receive a preset station by pressing
the corresponding number buttons • Check that.the audio .cables are connected pnoperly.
• Check that the TUNER input is selected . . ...
• Check that .the pmset station'is a,receivable. _____ ,
Skipping (mis-tracking)
• Check that the CD,isn’t cracked or dirty, .
frequency.
' “ r *
. .
' w Í
7
: "'
• Make sure that the player.isn't subjected to strong
• Check that the preset.memory.hasnlt been cleared., , vibrations.- . . . . .
because the power cord was. unplugged a long time. If
so, preset the station again.
■ r '
. .
'
CD automatically plays when power is
Interference with reception
turned on •
Remove all CDs before"turning yoLir unit DFR.The .
• Check for.interfererice from eléctrica.! appliances. If so,. player is designed to automatically begin playing when
tum them OFF. .. . ... . . . . the power is turned.ON.... . ..
• Ch.eck for interfere.nce.Trd.fh the;TV set If soffurn Ft, ,
0
FF,
■
0 r move .the ante
n
na way
f x>fr\
the TY--
'
50.